微生物降解前后COD差值法快速测定BOD

采用活性污泥曝气法降解前后COD差值的方法,进行了BOD快速检测的研究。条件实验结果表明,其适宜检测条件为:降解时间180 min;污泥量5 mL/100 mL;pH值7.0;温度25℃。模拟废水检测结果表明,该测定方法具有较高的重复性,5次测定的相对偏差小于6.5%,在BOD浓度为0~500 mg/L范围内,微生物降解前后COD差值与BOD5有良好的相关性,其相关系数达到0.98。因此,可以通过测定微生物降解前后COD值,实现快速BOD检测的目的,同时,也可实现COD和BOD一体化检测,这将是今后COD和BOD检测研究的发展方向之一。     

油田采出水处理系统用药剂进展

介绍了油田采出水回注处理包括水质净化和水质稳定两方面。通过应用分析得出最佳药剂投加顺序依次为阻垢剂、杀菌剂、缓蚀剂。指出新型药剂和绿色药剂研究的侧重点,提出开发无毒、无害的绿色工业水处理药剂是重要发展方向。     

Association of emergency room visits for respiratory diseases with sources of ambient PM2.5

Previous studies have reported associations of short-term exposure to different sources of ambient fine particulate matter(PM_(2.5)) and increased mortality or hospitalizations for respiratory diseases. Few studies, however, have focused on the short-term effects of source-specific PM_(2.5) on emergency room visits(ERVs) of respiratory diseases. Source apportionment for PM_(2.5) was performed with Positive Matrix Factorization(PMF) and generalized additive model was applied to estimate associations between source-specific PM_(2.5) and respiratory disease ERVs. The association of PM_(2.5) and total respiratory ERVs was found on lag4(RR = 1.011, 95%CI: 1.002, 1.020) per interquartile range(76 μg/m~3) increase.We found PM_(2.5) to be significantly associated with asthma, bronchitis and chronic obstructive pulmonary disease(COPD) ERVs, with the strongest effects on lag5(RR = 1.072,95%CI: 1.024, 1.119), lag4(RR = 1.104, 95%CI: 1.032, 1.176) and lag3(RR = 1.091, 95%CI: 1.047,1.135), respectively. The estimated effects of PM_(2.5) changed little after adjusting for different air pollutants. Six primary PM_(2.5) sources were identified using PMF analysis, including dust/soil(6.7%), industry emission(4.5%), secondary aerosols(30.3%), metal processing(3.2%),coal combustion(37.5%) and traffic-related source(17.8%). Some of the sources were identified to have effects on ERVs of total respiratory diseases(dust/soil, secondary aerosols, metal processing, coal combustion and traffic-related source), bronchitis ERVs(dust/soil) and COPD ERVs(traffic-related source, industry emission and secondary aerosols). Different sources of PM_(2.5) contribute to increased risk of respiratory ERVs to different extents, which may provide potential implications for the decision making of air quality related policies, rational emission control and public health welfare.     

Interactions of fluoroquinolone antibiotics with sodium hypochlorite in bromide-containing synthetic water: Reaction kinetics and transformation pathways

Seven popular fluoroquinolone antibiotics (FQs) in synthetic marine aquaculture water were subject to sodium hypochlorite (NaClO) disinfection scenario to investigate their reaction kinetics and transformation during chlorination. Reactivity of each FQ to NaClO was following the order of ofloxacin (OFL) > enrofloxacin (ENR) > lomefloxacin (LOM) > ciprofloxacin (CIP) ~ norfloxacin (NOR) >> pipemedic acid (PIP), while flumequine did not exhibit reactivity. The coexisting chlorine ions and sulfate ions in the water slightly facilitated the oxidation of FQs by NaClO, while humic acid was inhibitable to their degradation. The bromide ions promoted degradation of CIP and LOM, but restrained oxidation of OFL and ENR. By analysis of liquid chromatography with tandem mass spectrometry (LC-MS/MS), eight kinds of emerging brominated disinfection byproducts (Br-DBPs) caused by FQ_S were primarily identified in the chlorinated synthetic marine culture water. Through density functional theory calculation, the highest-occupied molecular orbital (HOMO) and the lowest-unoccupied molecular orbital (LUMO) characteristic as well as the charge distribution of the FQs were obtained to clarify transformation mechanisms. Their formation involved decarboxylation, ring-opening/closure, dealkylation and halogenation. Chlorine substitution occurred on the ortho-position of FQs's N4 and bromine substitution occurred on C8 position. The piperazine ring containing tertiary amine was comparatively stable, while this moiety with a secondary amine structure would break down during chlorination. Additionally, logK_ow and logBAF of transformation products were calculated by EPI-Suite^TM to analyze their bioaccumulation. The values indicated that Br-DBPs are easier to accumulate in the aquatic organism relative to their chloro-analogues and parent compounds.     

楼板对钢筋混凝土框架结构受力性能影响

汶川8级地震震害调查发现,这次地震中现浇钢筋混凝土框架结构多发生"强梁弱柱"型破坏,这与规范中"强柱弱梁"抗震设计原则相悖。为探究其原因,采用ABAQUS软件对钢筋混凝土带楼板框架和空框架结构进行了侧向加载情况的性能分析。通过对比纵向梁端钢筋应力变化和柱端钢筋应力变化,以及分析不同侧向位移对应的楼板钢筋的应力变化情况,指出楼板对梁端抗负弯矩能力的增强有很大贡献。研究了节点类型、楼板钢筋材性、侧向位移、梁高、梁跨和板厚等因素对纵向梁端处楼板有效宽度的影响规律,提出了负弯矩作用下梁端处楼板有效宽度的取值方法。     

多层混凝土框架工业厂房震害预测

近年来,由于我国地震的频频发生,部分钢筋混土框架结构的严重破坏和倒塌,特别是许多工业厂房,虽然是严格按照国家规范设计建造的,但是在罕遇地震作用下,该类厂房仍然受到了较大的破坏[2]。对单体多层混凝土框架工业厂房震害预测的步骤进行了简述,并结合某开发区一个算例进行了对比分析,针对多层混凝土框架工业厂房的特点,提出抗震设计建议,为抗震设计、加固提供一定的借鉴作用。     

多层砌体房屋震害预测分析

对目前我国房屋建筑中一种最为广泛应用的结构形式房屋——多层砌体房屋进行震害预测分析研究,简要介绍六种常用的多层砌体震害预测方法,易损性概率分析法或称为半经验半理论法、强度判别法、延性系数判别法、模糊类比法、人工神经网络法和结构理论计算法,在详细调查房屋基本情况的基础上,综合考虑以上几种方法,提出相应的震害预测的分析方法。对郑东新区砌体房屋进行震害预测,做出该地区的震害矩阵,并给出该地区砌体房屋在地震作用下的破坏程度及相应震害面积。     

遥感技术在城市建筑震害预测中的应用研究

长期以来,在城市的震害预测研究工作中,建筑物属性信息的主要获取方法是基于人工调查的传统方式。近年来,随着遥感技术的发展,尤其是高分辨率民用遥感卫星的成功发射,使得利用遥感技术进行城市震害预测成为可能。鉴于传统的信息获取方式存在的费时费力,数据获取周期长,数据信息时效性差等缺点,以郑州市中牟县的部分住宅区为例,对高分辨率遥感影像在城市震害预测中的应用做了相应研究。     

长沙市夏季大气颗粒物中重金属的形态及其源解析

对长沙市高开区、经开区、开福区以及马坡岭4个采样点夏季的大气颗粒物(TSP)浓度以及颗粒物中的重金属元素Cu、Zn、Mn、Pb和Cd的浓度和形态分布进行了研究分析,利用污染因子(Cf)对重金属元素的可保持能力进行了评价,并利用因子分析方法(PCA)分析TSP中重金属元素的主要来源。结果显示长沙市夏季TSP平均浓度为220.7μg/m3,表明长沙市颗粒物污染较严重。TSP中重金属元素浓度大小顺序为:ZnPbCuMnCd。从形态分布来看,大约63.3%~89.0%的Cu主要存在于可氧化态(F3),而Mn在这一态中分布最少。元素Zn、Cd则主要分布在弱酸提取态,分别占了70%和35%。Pb主要分布在残渣态,大约为24%~43%。由污染因子计算可知Cu、Cd和Zn比Mn、Pb有更高的迁移性。